Operation Mode | ON-OFF |
Current Rating | 15 Amps |
Operating Voltage | 120 Volts (AC) |
Contact Type | Normally Open |
Connector Type | Plug In |
Brand | HCDC |
Item dimensions L x W x H | 5.9 x 3.82 x 2.23 inches |
International Protection Rating | IP68 |
Number of Positions | 1 |
Specification Met | RoHS |
- HCDC HD060 Automatic transfer switch, an easy to mount 15Amp inline transfer relay provides switching between AC INPUT 2 (Utility or Shore Power) and AC INPUT 1 (Inverter or Generator) AC source. When AC INPUT 2 is powered, the load power will be switched to AC INPUT 2. When AC INPUT 2 is powered off, the load power will be switched to AC INPUT 1.
- Operating voltage AC 90 to 135V 50/60Hz. Maximum current 15 Amp. Transfer time less than 30mS (0.03 second). For most smart devices or computers, the switching action of 30mS time will not affect their normal operation.
- Internal four high power SPST relays switch design, effectively avoid the problem of DPDT relay high inductive load arcing. Live and Neutral wire are switched at the same time. The Ground wires of the two inputs and output are connected together internally and will not follow the switch on and off.
- IP68 Waterproof high level enclosure, suitable for indoor or outdoor use. Flame retardant rating V1. Case material: PC (Polycarbonate). Seal material: Silicone rubber. External screw: 304 stainless steel.
- AC INPUT 1 cable: Length 19 inch (0.5 meter), US standard NEMA 5-15P 3 prong plug. AC INPUT 2 and AC OUTPUT cables: Length 19 inch (0.5 meter), 14AWG (2.08 square millimeter) x 3 cores.
Anonymous Verified Buyer –
One input is connected to the grid, the other input is connected to my inverter (which is connected to a battery bank). On the output side, I have a UPS which will handle my network load for maybe 30 seconds, I kept it there to avoid reboots during the 30ms transfer time during a power outage – works perfectly, it’s awesome and SOOOO much cheaper than getting a PDU with ATS or getting an Inverter with built in battery charger.
Sarah Verified Buyer –
I’ve installed 3 of these now in the past few months and they’re all still working good. One in my own fish house to run the outlets/tv off a 2000 watt inverter. Another in a 5th wheel camper to run a residential 120 volt refrigerator off a 2000 watt inverter. And the third in a car hauler to run the 3 power outlets and 2 120 volt led lights off an inverter.
-patrick Verified Buyer –
After installing an inverter in my RV, used this transfer switch inline with the microwave power. Works as expected. Very happy.
Ours family Verified Buyer –
I was facing challenge because my UPS do not work on generator power, and they end up draining the battery and dying.
But, servers run well straight to generator, so I needed a transfer switch between UPS and servers to switch to generator.
It just works ! No interruption on server. Amazing, happy with it, works better than more expensive in rack solutions.
Steven M. Verified Buyer –
Didn’t work, just clicked repeatedly when shore power was disconnected. Tried two different inverter power sources with same result.
Dennis Verified Buyer –
Will require some wiring for plugs, or tie into source power or load. Works as advertised.Seems well built, well thought PCB inside.
Check back in 3 years to see if it lasted.
T Mat Verified Buyer –
This works perfectly in my bus conversion. I have used it for 1 full season and no issues.
mike hoyt Verified Buyer –
This is used on an RV to switch outlets between 120v AC from shore power and 120v AC from a sine wave inverter. The instructions are straightforward and the installation is easy
Ryan E Verified Buyer –
Great little transfer switch for 15amp loads. I use it at my off-grid cabin. One load is generator and load 2 is the Eco-flow Delta max. The devices switches between the two perfectly. It was exactly what I was looking for!
4.4 out of 5 stars Verified Buyer –
BURT Verified Buyer –
I was always unplugging and plugging my van mini fridge from shore power to inverter power and vice versa every time I left my driveway. Now I don’t have to worry about it. I used a 12″ lit end extension cord so I have confidence that the fridge has power, but after a month it works flawlessly. It was very easy to connect also. I hardwired the two inputs for a clean look.
Very happy with this switch.
Bill Ludwick Verified Buyer –
This auto transfer switch works great with a 3000 watt inverter that I purchased at the same time. My goal was to replace the Rv refrigerator in my 2022 fifth wheel with a residential refrigerator. There are several reasons for doing so but the main reason is safety. Anyway it came as advertised and works perfectly.
Yariel R. Verified Buyer –
Yo quisiera saber con que equipo el fabricante midio la velocidad de transferencia de este producto , es pesima la velocidad super retardado los tranfer de mucho menos valor en el mercado hacen la transferencia mucho mas rapido. yo voy a devolver el mio ya que lo que dicen no es cierto.